Outdoor PIR for the Wireless Smart Alarms.

Additional weatherproof Outdoor (external) Wireless PIR for use with the complete range of Smart Wireless Alarm Systems.

It is supplied with a unique Protective Rubber Hood which results in a narrow detection pattern (ideal for external applications avoiding false alarms from Cats & Foxes when mounted low and in the horizontal position). The front aperture can easily be widened (by using a knife or scissors) should you want a wider detection area.

It has a detection range of 30 - 45 ft and transmission distance back to any of the control panels of 450 ft (line of sight).

There are two ways to fit this PIR:

• Approximately 4 - 6 ft High (hidden away) in the horizontal position.
• High up looking towards the ground (experimenting with the angle so that the PIR doesn't detect small ground animals).

There is a built in 3 minute power saving delay (following each activation), but this can be changed to 15 seconds for applications more worried about a time delay than battery life, powered by a single PP3 battery.

The battery will operate for between 6 - 12 months in most applications (depending on number of activations) and has a built in low battery warning (a slow flashing red LED on the PIR) allowing for timely battery replacement.

There is no limit to how many additional PIR's can be added to our range of Smart Wireless Alarms.

• 1 x External Wireless PIR.
• 1 x Protective Rubber Hood.
• 1 x Mounting Bracket.
• 1 x PP3 Battery.
• 1 x Set of Screws.

• Frequency: 868 Mhz.
• Detection Distance: 30 - 45 ft.
• External Use: Yes.
• Detection Angle: Approximately 20 Degrees (with hood) 110 Degrees (without hood).
• Power Supply: 1 x PP3 Battery.
• Transmission Range: 450 ft (line of sight).
• Mounting Method: Adjustable Wall Bracket (using 2 screws).
• Power Saving: Yes (if set to 3 minutes between activations).
• Low Battery Warning: Yes (low flashing red LED when the battery is needing replacement).