Remote Location Battery 4G UltraDIAL Water & Flood Alarm

Remote location battery powered 4G Stand-alone UltraDIAL Water & Flood Alarm will contacts up to 3 x key-holders via Telephone & SMS if water is detected, ideal for many remote buildings prone to Flooding, supplied with:

• 1 x 4G UltraDIAL.
• 1 x Remote Control.
• 1 x Wired Waterbug Sensor. 

Supplied with 1 x Remote Control which is used to Arm & Disarm the Flood Alarm, additional ones can be added.

How it Works:

The UltraDIAL 4G Auto-Dialler is battery powered and fully Weatherproof (IP66) and is ideal for use in the most remote buildings (provided there is a mobile phone signal available). 

The Wired Water Bug Detector comes supplied with 12 ft of twin cable which is connected into the UltraDIAL N/O Inputs, the Water Sensor is for use inside a building.

The Water Bug Sensor mounted at the desired height above ground allowing for acceptable  levels of water to be ignored (or it could be mounted directly onto the floor if the application needed this).

If water is detected by the Waterbug Sensor it will trigger the UltraDIAL Alarm (provided it is in the Armed state), the UltraDIAL will then contact up to 3 key-holders by Telephone (with your own pre-recorded message) & SMS (either can be turned off if preferred).  

Perfect Water & Flood Alarm for Remote Buildings !!

Communication:

The Alarm communicates via the mobile phone networks (nano sim card required), it will contact up to three key-holders by Telephone (with your own pre-recorded message) & Text Message when activated.

We recommend using a SIM Card with a Network from the Country that the device will be used.

Other Uses:

This UltraDIAL can also be used as an Intruder Alarm using various Wireless Detectors & Sirens which can help share the investment, the options include:

• Wireless Door Contacts (007-0260).
• Wireless Vibration Sensor (007-1460).
• Indoor Battery Siren (007-0230).
• Outdoor Solar or Battery Siren & Strobe (007-0221).
• Standard PIR (007-0200).
• Standard PIR with Hood (007-1410).

Contacting Key-holders:

The Alarm will contact between 1 & 3 key-holders (depending on how you have chosen to program the alarm) by Telephone & SMS (either can be turned off whilst programming the alarm) when activated.

It will normally take take between 30 - 60 seconds to call the first key-holder when powered by battery, and quicker when powered by a plug in transformer or usb cable (this can vary depending on the mobile phone networks at the time).  

Recording Message:

You can record a 30 second message into the Alarm, which will be replayed to the key-holders when the Alarm calls them.

Power Supply:

The Alarm is powered by 3 x Lithium AA Batteries (supplied) which will last around 6 - 12 months in most applications, it can also be powered by a 5v Plug in Transformer or USB Cable where a power supply is available. If the power supply is used, the batteries can be kept in the Alarm as a backup although they will not be charged by the device.

Arming & Disarming:

The Alarm is Armed & Disarmed by using the Remote Control from up to 300 ft away, up to 9 Remote Controls can be used with each Alarm. It is also possible to Arm & Disarm the Alarm using the built in keypad if the remote control is not available.
If the Alarm is powered by the external 5v power source, then it is possible to Arm & Disarm the Alarm via SMS (text message).There is a 30 second Exit Delay built into the Alarm for easy use.

Receiving a Call:

When the Alarm calls the key-holders, there is the choice to:

• Listen to your pre-recorded message and do nothing (the alarm will contact the other key-holders).
• Listen to your pre-recorded message and press # on your telephone (this will disarm the UltraDial and prevent it from calling further key-holders).
• Listen to your pre-recorded message and press * on your telephone (this will prevent it from calling further key-holders, but keep the Alarm fully armed (ready for further activations).

Easy Programming:

It is very easy to program, probably the easiest GSM Alarm to program on the market today by using the small built in keypad, following some very simple instructions.

Weatherproof:

The UltraDIAL is fully weatherproof and rated at IP66, so can be used in most locations, it is not however designed to be submerged.

Low Battery:

The Alarm will send the primary key-holder a SMS (text message) if the batteries are getting low.

Status Report:

A status report can be obtained by sending the device a Text Message.

Mains Power Failure:

When the Alarm is being powered by an external 5v power supply, it will send the primary key-holder a SMS (text message) in the event of a Power Cut together with another when the power comes back on (provided you also have batteries fitted).  

Security Screws:

The lid is fitted with 4 x security screws and a tool is supplied as standard.

This is a very versatile Security device ideal for locations with limited access to Power, designed by Ultra Secure Direct.

If you need advice, please Contact Us !!

• 1 x 4G UltraDIAL Alarm.
• 1 x Remote Control.
• 3 x Lithium AA Batteries.
• 1 x Manual.
• 1 x Tool.
• 1 x surface mounting Water Detector.
• 4 metres of Cable.

UltraDIAL:

• Battery Power: 3 x Lithium AA Batteries (supplied).
• Battery Life: 6 months in most applications).
• Main Power: Yes (optional 5v DC plug in transformer).
• Programming Method: Easy Built in Keypad.
• Operates on 4G, 3G & 2G Networks.
• Wireless Transmission Range: 300 ft.
• Size: 6 1/4" x 3 1/4" x 1 3/4".
• Colour: Black.
• Wired Inputs: Yes (1 x Volt Free N/O or N/C).
• Cable Entry: 2 x Glands.
• Wireless Inputs: Yes (Wireless PIR's & Door Contacts).
• Wireless Outputs: Yes (Internal & External Sirens, PIR's).
• SIM Card Required: Yes (nano size).
• Calls Key-holders: Yes (maximum of three, which can be turned off).
• Sends Key-holders SMS: Yes (maximum of three, which can be turned off).
• Built in Siren: No (designed as a covert alarm).
• Mounting Method: 2 x Screw Holes in Flange.
• Weatherproof: Yes (IP66).
• Arming & Disarming Method: Remote Control, Keypad, Receiving A Call.
• Remote Operation on Battery: Yes (# to Disarm, * to Stop & Remain Armed).
• Remote Operation on Mains:  Yes (# to Disarm, * to Stop & Remain Armed, SMS to Arm, SMS to Disarm).
• Power Failure Notification: Yes (when used with a plug in transformer).
• Weekly Status Report: Yes (can be turned off).
• Low Battery Notification: Yes (to primary key-holder).
• Recording Message: Yes (this will be replayed to the key-holders when the alarm calls them).
• Frequencies:
• LTE-TDD B38/B40/B41.
• LTE FDD B1/B3/B5/B7/B8/B20/B28.
• UMTS/HSPA+ B1/B8.
• GSM/GPRS/EDGE 900/1800 MHz.

Water Bug Detector:

• Size of Detector: 2 1/4" x 3 1/4" x 3/4".
• Mounting Method: Surface (screw through middle flange).
• Length of Cable: 12 ft (can be extended to 150 metres).
• Type of Cable: 2-core.
• Supervised: No (not for use with the Water Bug 800 System).
• Connection Type: N/O.
• Fitted inside a Box: Yes.