Battery 4G UltraDIAL Vibration Alarm Kit.

Unique Battery powered 4G GSM UltraDIAL will contact up to 3 x Key-holders by Phone or/and Text when triggered, supplied with:

• 1 x 4G UltraDIAL.
• 1 x Wired Vibration Sensor.
• 2 x Remote Controls.
• 1 x Wireless Battery Siren.

The UltraDIAL and Siren are Armed & Disarmed by Remote Control, two supplied but additional ones can be added.

Designed for use in applications where you want an activation before a Door or Window has been forced open or someone has entered a room, examples could be:

• Back of a Parked Van.
• Gun Cabinet.
• Highly Restricted Room.
• Garage.

How it Works:

The UltraDIAL 4G Auto-Dialler is powered by 3 x AA Lithium Batteries (plug in power supply can be added if there is power available) and is fully weatherproof (IP66) and is ideal for use in the most remote locations (provided there is a mobile phone signal available). 

The Wired Vibration Sensor (supplied with 9 ft of twin cable which can be extended upon request) and is connected into the UltraDIAL input terminals, and would be fitted onto a sensitive location by suitable methods, the options are numerous including:

• Two Screws or Nuts & Bolts.
• Magnet.
• Double Sided Tape.

Fixing accessories are not supplied due to the fact that there are many ways to fit the Vibration Sensor. 

The Vibration Sensor is very Sensitive and is for Internal Use Only.

If the Vibration Sensor is triggered (whilst the UltraDIAL is Armed), the UltraDIAL will silently contact up to three key-holders by Telephone (with your pre-recorded message) & SMS (either can be turned off if required).

At the same time the Battery Internal Siren will activate in a different location to the hidden UltraDIAL, additional Internal or External Sirens can be added.

The Wireless Sirens is powered by 2 x AA batteries and can be fitted into any indoor location within approximately 150 ft from the Alarm.

Other Uses:

This UltraDIAL can also be used as an Intruder Alarm using various Wireless Detectors & Sirens which can help share the investment, the options include:

• Wireless Door Contacts (007-0260).
• Wireless Vibration Sensor (007-1460).
• Indoor Battery Siren (007-0230).
• Outdoor Solar or Battery Siren & Strobe (007-0221).
• Standard PIR (007-0200).
• Standard PIR with Hood (007-1410).

Contacting Key-holders:

The Alarm will contact between 1 & 3 key-holders (depending on how you have chosen to program the alarm) by Telephone & SMS (either can be turned off whilst programming the alarm) when activated.

It will normally take take between 30 - 60 seconds to call the first key-holder when powered by battery as the Alarm sits in sleep mode to preserve battery power (would be  quicker when powered by a plug in transformer or usb cable), this can also vary between mobile phone networks at any given time).  

Recording Message:

You can record a 30 second message into the Alarm, which will be replayed to the key-holders when the Alarm calls them.

Power Supply:

The Alarm is powered by 3 x Lithium AA Batteries (supplied) which will last around 6 - 12 months in most applications, it can also be powered by a 5v Plug in Transformer or USB Cable where a power supply is available. If the power supply is used, the batteries can be kept in the Alarm as a backup although they will not be charged by the device.

Arming & Disarming:

The Alarm is Armed & Disarmed by using the Remote Control from up to 300 ft away, up to 9 Remote Controls can be used with each Alarm. 
If the Alarm is powered by the external 5v power source, then it is possible to Arm & Disarm the Alarm via SMS (text message).There is a 30 second Exit Delay built into the Alarm for easy use.

Receiving a Call:

When the Alarm calls the key-holders, there is the choice to:

• Listen to your pre-recorded message and do nothing (the alarm will contact the other key-holders).
• Listen to your pre-recorded message and press # on your telephone (this will disarm the UltraDial and prevent it from calling further key-holders).
• Listen to your pre-recorded message and press * on your telephone (this will prevent it from calling further key-holders, but keep the Alarm fully armed (ready for further activations).

Wireless Sirens:

The Alarm can be paired to various devices which have built in Sirens, these will make the sound whilst the Covert UltraDIAL silently calls the key-holders without an Intruder knowing:

These Sirens & devices include:

• Indoor Battery Siren (007-0230).
• Outdoor Solar or Battery Siren & Strobe (007-0221).
• Standard PIR (007-0200).
• Standard PIR with Hood (007-1410).
• Wireless Vibration Sensor (007-1460).

Easy Programming:

It is very easy to program, probably the easiest GSM Alarm to program on the market today by using the small built in keypad, following some very simple instructions.

Weatherproof:

The UltraDIAL is fully weatherproof and rated at IP66, the Vibration Sensor is for Indoor Use only.

Low Battery:

The Alarm will send the primary key-holder a SMS (text message) if the batteries are getting low.

Mains Power Failure:

When the Alarm is being powered by an external 5v power supply, it will send the primary key-holder a SMS (text message) in the event of a Power Cut together with another when the power comes back on (provided you also have batteries fitted).  

Security Screws:

The lid is fitted with 4 x security screws and a tool is supplied as standard.

SIM Cards:

The Alarm communicates via the mobile phone networks (sim card required), and uses a nano SIM Card (PAYG or Contract). It will contact up to three key-holders by Telephone (with your own pre-recorded message) & Text Message when activated.

We recommend using a SIM Card with a Network from the Country that the device will be used.

This is a very versatile Security device ideal for locations with limited access to Power, designed by Ultra Secure Direct.

If you need advice, please Contact Us !!

• 1 x UltraDIAL 4G Alarm.
• 2 x Remote Controls.
• 3 x Lithium AA Batteries.
• 1 x Manual.
• 1 x Tool.
• 1 x Wired Vibration Sensor & 300 mm of Cable.
• 1 x Battery Internal Wireless Siren.

UltraDIAL:

• Battery Power: 3 x Lithium AA Batteries (supplied).
• Battery Life: 6 months in most applications).
• Main Power: Yes (optional 5v DC plug in transformer).
• Programming Method: Easy Built in Keypad.
• Operates on 4G, 3G & 2G Networks.
• Wireless Transmission Range: 300 ft.
• Size: 6 1/4" x 3 1/4" x 1 3/4".
• Colour: Black.
• Wired Inputs: Yes (1 x Volt Free N/O or N/C).
• Cable Entry: 2 x Glands.
• Wireless Inputs: Yes (Wireless PIR's & Door Contacts).
• Wireless Outputs: Yes (Internal & External Sirens, PIR's).
• SIM Card Required: Yes (nano size).
• Calls Key-holders: Yes (maximum of three, which can be turned off).
• Sends Key-holders SMS: Yes (maximum of three, which can be turned off).
• Built in Siren: No (designed as a covert alarm).
• Mounting Method: 2 x Screw Holes in Flange.
• Weatherproof: Yes (IP66).
• Arming & Disarming Method: Remote Control, Keypad, Receiving A Call.
• Remote Operation on Battery: Yes (# to Disarm, * to Stop & Remain Armed).
• Remote Operation on Mains:  Yes (# to Disarm, * to Stop & Remain Armed, SMS to Arm, SMS to Disarm).
• Power Failure Notification: Yes (when used with a plug in transformer).
• Weekly Status Report: Yes (can be turned off).
• Low Battery Notification: Yes (to primary key-holder).
• Recording Message: Yes (this will be replayed to the key-holders when the alarm calls them).
• Frequencies:
• LTE-TDD B38/B40/B41.
• LTE FDD B1/B3/B5/B7/B8/B20/B28.
• UMTS/HSPA+ B1/B8.
• GSM/GPRS/EDGE 900/1800 MHz.

Wireless Indoor Siren:

• Built in Siren: Yes (130 Decibel).
• Power Supply: 2 x AA Batteries.
• Wireless Range: 300 ft (line of sight).
• Size: 2 1/2" x 3 3/8" x 7/8".
• Colour: Cream.
• Siren Duration: 60 seconds (but remains fully armed).

Remote Controls:

• Power Supply: 1 x 3v Lithium Coin Battery.
• Wireless Range: 300 ft (line of sight).
• Operation Option: Arm or Disarm.
• Size: 3" x 1 3/4" x 1/2".
• Battery Life: 1- 2 Years (normal use).
• Warranty: 1 Year.

Vibration Sensor:

• Sensor Type: Vibration.
• Size: 1" x 1".
• Cable Length: 9 ft.
• Cable Type: 2-core.
• Output: N/A (going closed).
• Internal Use: Yes.
• External Use: No.